does anyone have any for sale, or does anyone have any measurements/drawings?

For a non-88 car.

Bizzump

Not sure how much I can help you, but it may be a start. I have an 85 with a 4 speed. The transmision are stock and the front I think came from a Jeep (not sure). There are some pictures of the side mounts in this link.

http://www.frontiernet.net/~jgunsett/EngineSwap.html

Hope it helps... Jack

------------------
If you can not run with the big dogs, stay on the porch!

I think I saw your car on the dyno at Ed's last year. You had those really well polihed snowflakes, didn't you?

Oh...thanks for the link. he he

The front mount is a piece of angle iron welded to the cradle and the rear has to be fabbed up and welded--very easy--but can be purchased from bubbo joe or 86fieroEarl or go to Rockcraw's site http://www.fieroaddiction.com and look at the detailed photos and you can figure it out.
Have fun Be safe

------------------
Proud Member of the North Florida Fiero club

4T60E Parks harness/ Rockcrawl chip-- more to come--

Yes, that was me. Hope to see you at this years swap meet.

Jack

Like jeffndebrus says the front mount is nothing but a simple peice of angle iron, You can either bolt it to the cradle (using number 8 or 9 hard bolts) the back mount is simple as well but you will need a welding gun.