Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  88 4cyl Waterpump almost done?

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Email This Page to Someone! | Printable Version


88 4cyl Waterpump almost done? by DtheC
Started on: 09-26-2005 02:33 AM
Replies: 0
Last post by: DtheC on 09-26-2005 02:33 AM
DtheC
Member
Posts: 3395
From: Newton Iowa, USA
Registered: Sep 2005


Feedback score: (2)
Leave feedback





Total ratings: 60
Rate this member

Report this Post09-26-2005 02:33 AM Click Here to See the Profile for DtheCSend a Private Message to DtheCDirect Link to This Post
I've been semi sucessful in gitting a new water pump and belt tensioner on. Everything is holds water and is bolted up except for the A/C compressor. In acessing those pesky wp bolts I removed the ac brace at the pully side, and the 3 bolts holding the compressor to the inboard brace(near the starter). I now know this was a mistake, but I was just having way too much fun. Right now the A/C compressor is totaly free except for the hoses. I'm having a hard time getting the comperssor lined up for the 3 10mm bolts on the inboard brace, what with the heat shield and all. I already tried firmly mounting the pully side, hoping the Inboard side would magicaly line up, but no such luck. I'm doing this jacked up on good ole flat cement, not on a lift. Any Ideas?

[This message has been edited by DtheC (edited 09-26-2005).]

IP: Logged
PFF
System Bot



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock