I'v got a used front brg. in a left knuckle, and I need to change it to the right side knuckle that is on the car. What is the best way to get it out of the one knuckle and into the other one?

Thanks, Yucon

https://www.fiero.nl/forum/Forum2/HTML/056279.html

Thanks Formula, I'l try it. MRJ told me someone was using the screws to push the hub off, but he didn't know much about it. When I looked at the hub I "got" it, but was concerned about busting the brg. Some of the methods I don't under, the one with the plate pushing from the rear, with a hole cut for the dust cover, there is nothing to push the hub out. And if you run the screws in from the hub side, your just tighting the dang thing . Or maybe I'm missing something. Anyway

Thank, Yucon

Use a drift punch and hammer to tap the edge of the bearing housing where it seats against the knuckle, as though you wanted to rotate the bearing housing in the knuckle. Also, spray rust breaker like PB Blaster at the joint between the bearing housing and knuckle. Once the rust is broken loose it comes out without too much of a fight.

JazzMan