Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Decklid Release wiring

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Decklid Release wiring by Stinkin_V8
Started on: 09-02-2004 04:22 PM
Replies: 1
Last post by: Stinkin_V8 on 09-02-2004 04:26 PM
Stinkin_V8
Member
Posts: 821
From: SK, Canada
Registered: Aug 2003

Feedback score: N/A
Leave feedback

Rate this member
Report this Post09-02-2004 04:22 PM Click Here to See the Profile for Stinkin_V8Send a Private Message to Stinkin_V8Direct Link to This Post
Anyone know the route of the wire to the trunk release? I've removed the engine wiring, including the right-hand bulkhead connector that goes through the firewall. I don't know where to find the wire from the switch!

[This message has been edited by Stinkin_V8 (edited 09-02-2004).]

IP: Logged
PFF
System Bot
Stinkin_V8
Member
Posts: 821
From: SK, Canada
Registered: Aug 2003

Feedback score: N/A
Leave feedback

Rate this member
Report this Post09-02-2004 04:26 PM Click Here to See the Profile for Stinkin_V8Send a Private Message to Stinkin_V8Direct Link to This Post
Cancel that.. Found a better diagram, it's in C500 A1

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock