I'm just asking this to help a fellow Fiero owner out.

He is in the middle of an engine swap, and the interior was gutted before the purchase. He needs to get the power windows down without the switches or battery installed? Is there a trick to get them down? If he needs the switches... Anyone have spares?

Thanks,
Greg

look at the switch connectors on the console, if it is gutted then you should see easy

on all pink wire hot in run
left hand blue wire=up
brown=down
black=ground

right hand blue/white=up
tan =down
black=down

applying 12volts to these wire and gound should be able to make it go up or down, use jumper wires
.........good luck..................if not look at this diagram.........you need adobe to read.wiring pdf.......special thansk to elmo for providing this. ...........