Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Distributor power supply

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Distributor power supply by ace35
Started on: 03-15-2004 01:05 PM
Replies: 1
Last post by: $Rich$ on 03-15-2004 01:17 PM
ace35
Member
Posts: 1773
From: NC
Registered: Dec 2003

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-15-2004 01:05 PM Click Here to See the Profile for ace35Send a Private Message to ace35Direct Link to This Post
For the starter killer in my security system it says to cut the power supply to the distributor. I'm just nervous about doing this and wondering if anyone could talk me through it. Where is it, where would be best to cut, if I should cut, etc...
IP: Logged
PFF
System Bot
$Rich$
Member
Posts: 14575
From: Sioux Falls SD
Registered: Dec 2002

Feedback score:    (20)
Leave feedback





Total ratings: 398
Rate this member
Report this Post03-15-2004 01:17 PM Click Here to See the Profile for $Rich$Send a Private Message to $Rich$Direct Link to This Post
if your a little leary on going that route, just splice it into the Fuel pump relay

------------------

Rich AIM: ONE FAST 2M8

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock