Anybody know a good source for the bolt set to mount the Holley carb on the Torker II manifold?

Edelbrock, Jegs, and Summit don't have a listing.

------------------
Arn Brown, 1985 Fiero GT, 15.474 ET stock
Mods underway.

I just took the riser and all the itake bolts with me to a hardware store and bought all new bolts/studs in stainless steel. The studs for intake where the riser is, supplied by Edelbrock, are not good to use. I measured and used bolts. (the stock ones are too short). All the bolts are metric except the carb stud threads. Those are SAE.

------------------

Happiness isn't around the corner...
Happiness IS the corner.

If you're talking about the four mounting points that hold the carb to the intake, Jegs and Summit both carry them. ARP studs and nuts, black oxide, p/n 070-200-2401 for the standard length. Proform standard length 778-66338. Those are Jegs p/n's.

John Stricker

quote Originally posted by Arns85GT: Anybody know a good source for the bolt set to mount the Holley carb on the Torker II manifold? Edelbrock, Jegs, and Summit don't have a listing.

Here, Autozone and Advance Auto have them on the shelf in a set of 4.

Gene