Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  what are the 2.5 piston and rod specs?

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
what are the 2.5 piston and rod specs? by AgentD
Started on: 11-10-2003 10:05 PM
Replies: 1
Last post by: befarrer on 11-12-2003 01:01 PM
AgentD
Member
Posts: 164
From: Enterprise, AL USA
Registered: Dec 2001

Feedback score: N/A
Leave feedback

Rate this member
Report this Post11-10-2003 10:05 PM Click Here to See the Profile for AgentDSend a Private Message to AgentDDirect Link to This Post
What are the size specifications for a 2.5l l4 from and 84? cas from what i could find the bore is 4 inch so any 350sbc pistons would fit. thanks for the help
D,
IP: Logged
PFF
System Bot
befarrer
Member
Posts: 1962
From: Westlock, Alberta, CANADA
Registered: Aug 2002

Feedback score: N/A
Leave feedback





Total ratings: 61
Rate this member
Report this Post11-12-2003 01:01 PM Click Here to See the Profile for befarrerSend a Private Message to befarrerDirect Link to This Post
I found that the piston pin on the 2.5 is 0.0002" bigger than a 350, which is pretty much the same size. The bottom of the SBC connecting rods are 0.4 " larger I think. They can be used though, with some machining.

------------------

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock