What size socket is needed for intake manifold bolts on a 2.8L. The biggest I have is an E14 and it is too small. Also who would carry it?

Quick wouyld be appreciated - in the middle of a head gasket job and ran into this problem

If you're talking about the top bolts holding down the plenum, they take a 10mm 12 point socket. good luck

Phil

------------------
87 FIERO GT 2.8 5spd
0-60 in 6.8 seconds!
If you found my advice helpful, please take the time to give me a positive rating. Thanks

Thanks GT,

10MM 12 point it is. I must be getting blind in my old age. I thought I tried all my twelve points first.

And the little bolt holding the TBI heater lines on is an 8mm 12pt socket.

JazzMan