Torque specs for front shocks, quickly please

Click here to visit The FieroStore | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

Torque specs for front shocks, quickly please by fiero go fast

Started on	: 07-16-2003 05:47 PM
Replies	: 2
Last post by	: fiero go fast on 07-16-2003 06:03 PM

fiero go fast
Member

Posts: 1728
From: Royersford, PA
Registered: Apr 2002

Feedback score: N/A
Leave feedback

Total ratings: 60
Rate this member

Report this Post07-16-2003 05:47 PM

I've got a haynes and a chiltons book. Both books shows a different torque spec for the two upper and one lower bolt for the front shocks. Can someone tell me what I should torque the top two bolts and lower bolt to?

Matt

------------------

IP: Logged

PFF

System Bot

GTDude
Member

Posts: 9056
From: Keysville, Virginia, USA
Registered: Nov 2001

Feedback score: N/A
Leave feedback

Total ratings: 287
Rate this member

Report this Post07-16-2003 05:57 PM

Just tighten them tight without ringing them off. It's not critical unless you don't know which end of a wrench to pick up.

Okay
upper 20 each
lower 51

Phil

------------------
87 FIERO GT 2.8 5spd
0-60 in 6.8 seconds!
87 FIERO CPE 2.5 5spd
86 FIERO SE 2.5 AUTO
87 FIERO GT 2.8 4SPD
If you found my advice helpful, please take the time to give me a positive rating. Thanks

IP: Logged

fiero go fast
Member

Posts: 1728
From: Royersford, PA
Registered: Apr 2002

Feedback score: N/A
Leave feedback

Total ratings: 60
Rate this member

Report this Post07-16-2003 06:03 PM

Good good, thats what i got out of the haynes =). I will just go with that then. + for you!
Thanks
Matt

IP: Logged

All times are ET (US)


T H I S I S A N A R C H I V E D T O P I C

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock