My side ground effects on the fiero are badly cracked so i was going to take em off plastic repaire them and put them back on but i was looking at them and they look like a pain in the a** and i think i already asked this question but couldent find it in the archives...so can some1 tell me a step-by-step (cuz im dumb lol) instructions for taking em off?
ThanX
Brad

They are held on by a bunch of rivets and fastened to the front fenders and rear q pannels by snap in type clips or locking tabs. Open the door and remove the three little plastic covers on the bottom door seal. these covers cover (one each) three rivets. punch out the center of the rivets and drill out the head of the rivets. Do all the rivets along the bottom of the GFX then take out the small screws in the inner fender that may screw into the GFX. Get a larg flat tip screw driver and CARFULLY pry the GFX tab or "ears" down and slide the GFX off of the fender. The fenders have one of these tabs and the rear q pannel has two. You will see what I mean when you get one off, then you will get the rest alot easyer. The door seal has a good hold on the GFX but you gan pull it out with a little effert.

lol holy crap thats alot of werk lol...ok well im off..thanX buddy!
Brad