Torque Specs for flywheel and clutch plate

Click here to visit the donation page | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions - Archive

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

Torque Specs for flywheel and clutch plate by paulcal

Started on	: 09-09-2003 03:30 PM
Replies	: 1
Last post by	: Indiana_resto_guy on 09-09-2003 05:12 PM

paulcal
Member

Posts: 2608
From: Jacksonville, Fl
Registered: Oct 2002

Feedback score: (1)
Leave feedback

Total ratings: 96
Rate this member

Report this Post09-09-2003 03:30 PM

I can't find my Hayes manual anywhere and I had to put the flywheel and clutch plate back on today. The sequence looks straight forward but I was unsure of the actual torque values for each.
I torqued the flywheel down to 50ft/lbs and the clutch plate to 30ft/lbs. Am I even close and if not will this cause me any problems?

------------------

The 2.8 to 2.8 swap has
begun.
Vini, Vidi, Velcro.
I came, I saw, I stuck around.
AIM-jaxpac257

IP: Logged

PFF

System Bot

Indiana_resto_guy
Member

Posts: 7158
From: Shelbyville, IN USA
Registered: Jul 2000

Feedback score:

(15)
Leave feedback

Total ratings: 163
Rate this member

Report this Post09-09-2003 05:12 PM

Send a Private Message to Indiana_resto_guy

45 to 55 on the flywheel and 15ft. lbs. on the pressure plate.
Good enough I would say.

IP: Logged

All times are ET (US)


T H I S I S A N A R C H I V E D T O P I C

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay

Copyright (c) 1999, C. Pennock