Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Distributor for the 2.8

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Distributor for the 2.8 by Scythe
Started on: 07-19-2003 12:37 AM
Replies: 2
Last post by: LT1Guy on 07-21-2003 05:55 PM
Scythe
Member
Posts: 1055
From: Burke, Virginia
Registered: Apr 2003

Feedback score: N/A
Leave feedback

Rate this member
Report this Post07-19-2003 12:37 AM Click Here to See the Profile for ScytheSend a Private Message to ScytheDirect Link to This Post
Does anyone know where they sell [new/rebuilt] high performance distributors for the 2.8?
IP: Logged
PFF
System Bot
avengador1
Member
Posts: 35468
From: Orlando, Florida
Registered: Oct 2001

Feedback score:    (7)
Leave feedback





Total ratings: 571
Rate this member
Report this Post07-19-2003 10:53 AM Click Here to See the Profile for avengador1Send a Private Message to avengador1Direct Link to This Post
If you find one let us know. The only ones I have seen are stock rebuilds. If you are doing a carbed V6 engine you can get a high performance distributor from an S-10.
IP: Logged
LT1Guy
Member
Posts: 21
From: Barnesville GA USA
Registered: Sep 2002

Feedback score: N/A
Leave feedback

Rate this member
Report this Post07-21-2003 05:55 PM Click Here to See the Profile for LT1GuySend a Private Message to LT1GuyDirect Link to This Post
Its not hard to rebuild a stock one yourself to high performance specs...there are some pretty good directions on http://www.thirdgen.org. The main culprit on the stockers is usually excessive endplay, which is easily fixed with a shim kit from Moroso. The 2.8 dist that I rebuilt had over .030 endplay, more than twice the recommended spec.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock