Okay, if you are going to pull the intake so you can do the valve cover gaskets, what gaskets will you need? Any other parts that might be helpful? And since I am there, might as well repaint. What is a good match for our Fiero Red? Thanks,

Intake manifold gasket set - FelPro #MS93020 - $38.82

Valve Cover Gasket set - FelPro #VS50077R
- $28.30

Paint - "Dupli-Color" engine enamel, part # DE 1632 Chrys Ind Red - available at most autoparts store ( silver can with red 350 on it )

------------------
( the above was the thoughts, views, and opinions of a disgruntled Fiero mechanic, and do not express or
imply those of West Coast Fiero, Fieros West, or any other organization - just that of this poor
bastard ) :)

Eric Nelson
Technician,
West Coast Fiero
310-305-4111

Thanks, that gets me started. What about O rings? I willprobably get new vaccum lines and coolant tubes while I am in there since these have not been touched since new.

The Intake kit comes with all o-rings you will need, however I would personally go with Rodney Dickman's stainless steel vacum line setup - you would never worry about vacum lines agian in all probability

------------------
( the above was the thoughts, views, and opinions of a disgruntled Fiero mechanic, and do not express or
imply those of West Coast Fiero, Fieros West, or any other organization - just that of this poor
bastard ) :)

Eric Nelson
Technician,
West Coast Fiero
310-305-4111