Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  TCC Lockup Connector Wiring

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
TCC Lockup Connector Wiring by Paul Prince
Started on: 02-12-2003 11:03 AM
Replies: 1
Last post by: GTDude on 02-12-2003 12:42 PM
Paul Prince
Member
Posts: 2935
From: Kansas City, MO
Registered: Dec 2002

Feedback score: N/A
Leave feedback





Total ratings: 110
Rate this member
Report this Post02-12-2003 11:03 AM Click Here to See the Profile for Paul PrinceSend a Private Message to Paul PrinceDirect Link to This Post
The TCC lockup connector (from the harness) is a square 4 pin and only A and D have wires in them. The connector on the trans has 3 pins coming out of it? A, D, and C (or B). Anyone know why? Why this does not connect to the harness connector...Paul
IP: Logged
PFF
System Bot
GTDude
Member
Posts: 9056
From: Keysville, Virginia, USA
Registered: Nov 2001

Feedback score: N/A
Leave feedback





Total ratings: 287
Rate this member
Report this Post02-12-2003 12:42 PM Click Here to See the Profile for GTDudeDirect Link to This Post
These trans are used for many diff applications. Some of the later applications give feedback to the ecm, which is what, I suspect that the other terminal is for.

Phil

------------------
87 FIERO GT 2.8 5spd
0-60 in 6.8 seconds!

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock