Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  starter wires, no juice on the trigger wire

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
starter wires, no juice on the trigger wire by cjgable
Started on: 05-06-2002 10:28 PM
Replies: 1
Last post by: kyote on 05-07-2002 07:13 AM
cjgable
Member
Posts: 1198
From: Fort Worth, Tx, USA
Registered: Dec 2001

Feedback score: (2)
Leave feedback

Rate this member
Report this Post05-06-2002 10:28 PM Click Here to See the Profile for cjgableSend a Private Message to cjgableDirect Link to This Post
Can anyone help. I'm kinda stuck/don't know what to check. I am getting juice from the ignition past the clutch, but the trigger wire on the solenoid has no juice when the ignition is turned. Is there a place near the battery to see if juice is getting to the engine compartment? Does anyone know a couple spots to check with the testlight while the ignition is being turned? I don't know where else to look. Thanks for any help.

------------------
'87 2.8v6 5spd

IP: Logged
PFF
System Bot
kyote
Member
Posts: 1232
From: Germantown, Wisconsin - Metro Milwaukee Area
Registered: Sep 2001

Feedback score: N/A
Leave feedback

Rate this member
Report this Post05-07-2002 07:13 AM Click Here to See the Profile for kyoteClick Here to visit kyote's HomePageSend a Private Message to kyoteDirect Link to This Post
At the junction block, just behind the battery,.. check the heavy gauge purple wire that goes to the starter.. That's the wire coming from the neutral saftey switch at the clutch.

------------------

'85 SE - '86 Fastback SE - '99 Chevy K-1500 Z-71 - '00 HD 1200XL Sportster

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock