Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  motor exchange

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
motor exchange by critter's fiero
Started on: 04-30-2002 09:55 PM
Replies: 1
Last post by: m0sh_man on 04-30-2002 10:29 PM
critter's fiero
Member
Posts: 91
From: Rockford Il.
Registered: Apr 2002

Feedback score: N/A
Leave feedback

Rate this member
Report this Post04-30-2002 09:55 PM Click Here to See the Profile for critter's fieroSend a Private Message to critter's fieroDirect Link to This Post
Excuse my lack of knowledge, does a s-10 2.8 V6 long or short block motor interchange with my fiero 2.8 V6 ? or what else is the same ????.............thanks- Critter
IP: Logged
PFF
System Bot
m0sh_man
Member
Posts: 8460
From: south charleston WV 25309
Registered: Feb 2002

Feedback score:    (23)
Leave feedback





Total ratings: 163
Rate this member
Report this Post04-30-2002 10:29 PM Click Here to See the Profile for m0sh_manSend a Private Message to m0sh_manDirect Link to This Post
pretty much not at all, but if you wanna do the same work to put that 2.8L into the car jsut go buy a 3.4L pushrod from a 93-95 camaro it takes the same work, you have to use the fiero 2.8L intake and drill the new starter holes on the other side of the block scince the s10 2.8's were built for rear wheel drive front engine the starter bolts are on the wrong side.

matthew

IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock