Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  Engine Bearing sizes??

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
Engine Bearing sizes?? by BigNickDog
Started on: 03-27-2002 02:51 PM
Replies: 1
Last post by: 85GToronto on 03-27-2002 03:17 PM
BigNickDog
Member
Posts: 188
From:
Registered: Jan 2002

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-27-2002 02:51 PM Click Here to See the Profile for BigNickDogSend a Private Message to BigNickDogDirect Link to This Post
Hi all,
Thanks for all the info regarding Oil pan removal. Well now that the pan is off, how can I tell what size bearing was in there?? I looked at the bottom side of the bearing for size(Std, -10 etc) and all it says is:
GM
AL-6
4 89
The reverse bottom says:
B 9

Does any one know what this means? I have std sizes already, should I take them back or are they going to work?

Thanks.

IP: Logged
PFF
System Bot
85GToronto
Member
Posts: 927
From: Red Deer, Alberta, Canada
Registered: Dec 2001

Feedback score: N/A
Leave feedback

Rate this member
Report this Post03-27-2002 03:17 PM Click Here to See the Profile for 85GTorontoSend a Private Message to 85GTorontoDirect Link to This Post
I'd get a Haynes manual or something similar and a caliper and check that the journal has not been machined. If you have an accurate caliper its a sure way to check and pretty easy too. I have no idea if that part# will help you. A good manual will give the stock journal sizes.
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock