I want to wire in a switch to a power inverter that I am going to be using for my MP3 Computer. My question is, is there any good leads to that I can splice into up front?

Thanks

------------------

huh I would have to get back with ya on that....I ran a lead from the batt. to a terminal block up under the front hood. as far as a splice....get the multimeter out and poke around.

I was thinking of "hooking" in to the wire for the headlights.
Bad Idea? or would it be easier to run a seperate line back to the battery?

------------------
Going fast in the Corners!

I would access it off the cig lighter wires, but that's not up frt, Pretty much and red or orange wire should have power all the time, a pink wire has power with the key in run position.

by the way, nice car!

Pete

[This message has been edited by PBJ (edited 03-13-2002).]

quote Originally posted by PBJ: by the way, nice car! Pete

Thanks! Your wife's car is pretty nice too!

Hey did you get anything together for those radiator support braces?
I should have the car totally in my name and the rims on by the end of next week. Can't wait.

I am working on a bracket setup, and hey if you are having any trouble putting the car in your name...you could just put it in my name...

Pete

quote Originally posted by PBJ: I would access it off the cig lighter wires, but that's not up frt, Pretty much and red or orange wire should have power all the time, a pink wire has power with the key in run position. [This message has been edited by PBJ (edited 03-13-2002).]

Wouldn't the inverter draw too much power through that particular wire. (the wire for the cigarette lighter) ?
Just curious.

Don't know how feasable this is but can't you take a feed of the fuse block under the stearing column, just use a spade connector to plug onto one of the power feeds on the back. You'll need to look at a wiring diagram to see which ones would take the load though.

Dave E http://www.ltlfrari.com