Lost My Paperclip (Page 3/3)
Romsk APR 16, 08:45 AM
I make a Fiero GT ALDL Adapter and GUI. To lower the cost, I had to make my own 3D printed ALDL connectors because I could not find a cable with the connector pins wired they way I need them. I was buying a 12 pin cable, cutting off the cable, Dremmeling it out, adding my desired wires, and potting it back up with resin. It was a lot of work. My 3D connectors were not only lower cost but saved me a ton of time.

I took that connector design and created a new part which I call the "The Fiero Paperclip Adapter".

Click here for details

I keep one handy in my glove box.

It's harder to lose than a paperclip and it even comes with a mini Torx screw driver and and instruction placard teathered to it. It allows you to go from NORM to DMDIAG Mode at the flip of a switch. All the Error Codes are listed on the placard. It can even put the ECM in DMFACT mode so you can test the Limp Home Mode of the ECM.

The Fiero Store didn't want to sell it because they already sell a similar solution from the NIFE forum. So, I sell it for cost plus shipping - which is lower cost than if it was retail.
------------------
Paul Romsky

[This message has been edited by Romsk (edited 04-16-2025).]

TheDigitalAlchemist APR 17, 06:12 AM

quote
Originally posted by Romsk:

I make a Fiero GT ALDL Adapter and GUI. Chicks dig it, fun at parties. A great conversation piece for your coffee table.



That sounds neat, will order one from you tomorrow. xoxo

I found my paperclip, it was behind my ear (where my pencil used to be)