Rock Auto has closeout prices on Moog rear hubs for 84-87 Fieros - under $18! I'd say get 'em while they last. Moog has always been a reputable brand in my experience.

------------------


87 GT, Ramjet 350 SBC, 6-Spd
Melbourne, FL

[This message has been edited by animal (edited 11-25-2012).]

NICE! thank you +1 i bought 3

[This message has been edited by Niterrorz (edited 11-25-2012).]

Nice find! I just bought a bunch of parts for my Lebaron swap from them. Fast service, great prices. Must be sold out now. No Listing that I can find

[This message has been edited by infinitewill (edited 11-25-2012).]

quote Originally posted by infinitewill: Nice find! I just bought a bunch of parts for my Lebaron swap from them. Fast service, great prices. Must be sold out now. No Listing that I can find

http://www.rockauto.com/cat...249107,parttype,1636

its in the drop down menu you have to select the part.

Thanks ordering 2

dont forget your 5% discount code
14DBBA82554B

[This message has been edited by FieroMontreal (edited 11-25-2012).]

Thanks! Just ordered 2 myself..

------------------




1999 GMC Jimmy 2dr 4x4
1985 Fiero GT 3800 N/A ...3800 S/C being rebuilt now.
1984 Fiero Indy #1098 w/ Centerline Wheels,Hooker Tri-y header and Indy Scoop with Strobe's
1984 SE Daily Driver

said they are 1986 hubs. Are they same on the 1984 ? I need two

Ron T

------------------

signature by F-I-E-R-O (My Indy on right / #1 IMS)

quote Originally posted by Niterrorz: http://www.rockauto.com/cat...249107,parttype,1636 its in the drop down menu you have to select the part.

Thanks man I never would have found it at the rate I was going

Dr. W.

picked up 2

Looks like my order went through... added to my big pile of parts to install over the winter.

Thanks

------------------
86 Fiero GT 4spd - (pending L67 swap)
98 GTP - Some mods

quote Originally posted by paced84: said they are 1986 hubs. Are they same on the 1984 ? I need two Ron T

The rears are all the same from 84-88

I just picked two up myself thanks a bunch!!

The catch is Moog/National "private label". I received 2 last week and they were in a box with a name that I did not recognize. They appeared to be of good quality so we shall see. I'll be in the shop tomorrow and pass on the name. For $18 you really can't go wrong . The last Timken hubs that I purchased were $80.00 each. These Rock Auto hubs might be Chinese but they have no markings....Hmmm I wonder.

------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Powerlog manifold, Northstar TB, LS1 MAF, 3" Flotech Afterburner Exhaust, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE "

What's the "private label box" all about? Are they still Moog?

It may be that they are made by Moog/National but packaged in a box with a private label like NAPA, Duralast, O'Rielly or some other retailer.

Glad I saw this thread, just ordered a pair myself. They must have had a lot in stock, as just the posts above mine, a lot of em have been purchased!


The total came to $ 43.14 for a pair, with ground shipping.

[This message has been edited by JohnWPB (edited 11-25-2012).]

So these will work for the '88 also?

quote Originally posted by boostedbird: So these will work for the '88 also?

Yes..

With a little molding, you can also use these on the front of an '88. Save yourself a pile of money, and make your car more future proof.

quote Originally posted by SlowGuitarMan: With a little molding, you can also use these on the front of an '88.

How so ?

I didn't find the location for the discount code, but ordered a pair anyway. I believe the passenger side on my 87 GT is still the original. I did have the driver's side replaced a few years back. More parts for my storage room.

quote Originally posted by SlowGuitarMan: With a little molding, you can also use these on the front of an '88. Save yourself a pile of money, and make your car more future proof.

I'd like to know more about this also

quote Originally posted by Old Lar: I didn't find the location for the discount code, ...

Should've looked harder, you could have saved an extra $1.78, .
It is to be entered where they ask you to list "who referred you"/"how did you hear about us".

thanks, ordered 2 for the Fiero as spares.

I was able to drill down, and get a direct link to the hubs, if anyone is looking to buy them.

This is the direct link to the spec sheet.

I was about to post this as well! I didn't need them but I picked up a pair since I was ordering some other stuff anyway.

New pre-87 v6 flywheels are also < $30, and the good Wix oil filters are about $4.

Just bought 2 hubs to add to my Fiero cache.

Just ordered myself a pair, what a great deal!

Has your orders shipped yet?

Mine still hasn`t shipped and they are usually pretty good at shippiung same day or next day. It`s probably the first time I have an order on rock auto that makes it to the 2nd day without shipping.

I just got shipment notification. Placed my order Sunday at 9:15 pm central.

Dr. W.

------------------
Is your Fastback GT's trunk seal shot? My Gen III replacement GT trunk seals with solid molded corners are now in production. $95 + $15 flat rate shipping to the US (contact me for international shipping rates) or buy two and pay only a single shipping rate! More info can be found here GT Trunk Seal Project

Ordered Sunday, shipped Monday.

Like John, I found the spec sheet. Ordered a pair to go on the shelf, too.

Dennis, did you ever find out what brand yours were packaged under?

thanks! Just ordered a pair with discount

------------------
<---- did you buy Cliff a beer?
......................................................www.northtexasfieroclub.org

Moog/National part # 513011K is the same part # Timken uses for their hub bearing unit. Found this in the Timken catalog.

Two on order here last night, shipping in progress.

Ordered mine Sunday night, got confirmation email that they were picked up by FedEx at 3:08 PM this afternoon (Tuesday). They estimate delivery for Friday.


As a bit of a coincidence, I just drove my car home from the paint shop today, and the right real caliper locked up. Looks like while I have it apart, may as well put my new hubs on as well!

[This message has been edited by JohnWPB (edited 11-28-2012).]

I ordered a pair just now. I checked O'Reilly's website and they list two brands, 38 bucks each and 62 bucks each. If these are a quality match for the higher priced piece, I saved over 70 bucks after shipping.

Ordered a pair myself! Thanks man

------------------
'88 GT

I ordered mine Monday night and they are due to arrive tomorrow.

I am really curious to see if these are really what Rockauto says they are and not some Chinese knockoffs. I was able to get two NOS AC Delco units from my local parts guy and I paid $80 or so for them. Has anyone received them yet and looked at them carefully?