Hi everyone,

I have a C5 Corvette dash from a 99 that I was going to put in my Fiero, but ended up selling the car before I did this one. I had cut apart a junk C5 Corvette dash to test fitment a few weeks before and ended up selling that one on eBay for $280. This one is in much better condition, though it does have some small scratches in the vinyl from glass bits.

Here's a link to the one I sold on eBay so you can get an idea of what it would look like. I don't have the console and radio trim with this one, but you can buy those on eBay for under $100.
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7998985877&rd=1&rd=1

Email me for actual photos of this unit. I'll include the 99 Gauge cluster with purchase for only $125 more.

Hey, that's pretty nice looking. I'd say it's better than a lot of swaps I've seen where the dash takes up way too much space or otherwise looks too out-of-place. I'd get that if I had enough money burning a hole in my pocket

[This message has been edited by FieroGT42 (edited 11-21-2005).]

That is a very tempting offer, although I need to stay focused on the motor at this time. $150 for the dash and gauges and I think I'd buy it, but I realize that is about $100 less than you are looking for. And I'd be worried about making the guages and HVAC controls work, I am not exactly a wiring genius.

Nice piece, would look good in a Fiero, but bad timing for me.

------------------

"all pushrod motor are better than the dohc because it has less rotational mass"
-rick17, MyMonte member, owner of a 3100 Monte Carlo LS

Email sent.

Nolan