Pennock's Fiero Forum
  Technical Discussion & Questions - Archive
  3 speed auto to 4 speed auto (4t65)

T H I S   I S   A N   A R C H I V E D   T O P I C
  
Email This Page to Someone! | Printable Version
3 speed auto to 4 speed auto (4t65) by Admiral Jedi
Started on: 01-29-2010 08:13 PM
Replies: 4
Last post by: flimbob on 01-30-2010 08:47 AM
Admiral Jedi
Member
Posts: 121
From: Spring Hill, TN, USA
Registered: Dec 2009

Feedback score: N/A
Leave feedback

Rate this member
Report this Post01-29-2010 08:13 PM Click Here to See the Profile for Admiral JediSend a Private Message to Admiral JediDirect Link to This Post
I'm a little unclear about one little part. When swapping in the new transmission, would I need to change the shifter assembly at all? What all is involved in that?

Do I need to get a new one? Thanks!
IP: Logged
PFF
System Bot
skuzzbomer
Member
Posts: 7492
From: Nashville
Registered: Sep 2009

Feedback score: (3)
Leave feedback





Total ratings: 92
Rate this member
Report this Post01-29-2010 08:49 PM Click Here to See the Profile for skuzzbomerSend a Private Message to skuzzbomerDirect Link to This Post
I'm pretty sure you need to change shift assemblies... Check The Cave to be sure.
IP: Logged
Mike Gonzalez
Member
Posts: 5093
From: Colorado Springs, CO. USA
Registered: Jul 2001

Feedback score: (1)
Leave feedback





Total ratings: 130
Rate this member
Report this Post01-29-2010 10:19 PM Click Here to See the Profile for Mike GonzalezSend a Private Message to Mike GonzalezDirect Link to This Post
The stock shifter will work, you can modify it if needed to reach 1st gear. You may need to mod the cable bracket on the trans end.
IP: Logged
MstangsBware
Member
Posts: 11509
From: TEXAS
Registered: Mar 2002

Feedback score:    (108)
Leave feedback





Total ratings: 459
Rate this member
Report this Post01-29-2010 11:53 PM Click Here to See the Profile for MstangsBwareSend a Private Message to MstangsBwareDirect Link to This Post
 
quote
Originally posted by Admiral Jedi:

I'm a little unclear about one little part. When swapping in the new transmission, would I need to change the shifter assembly at all? What all is involved in that?

Do I need to get a new one? Thanks!


As stated by Mike the stock shifter will work fine, have to modify the shift lever/cable bracket on the trans, built pass side axle and make/buy the correct mounts.
IP: Logged
flimbob
Member
Posts: 645
From: Plano, Texas, USA
Registered: May 2008

Feedback score:    (20)
Leave feedback

Rate this member
Report this Post01-30-2010 08:47 AM Click Here to See the Profile for flimbobSend a Private Message to flimbobDirect Link to This Post
Stock ecm can not handle the electronic trannys( 4t60e, 4t65 ), but a 4t60( 440t4 ) can be used. Search for "4t60 install".
IP: Logged



All times are ET (US)

T H I S   I S   A N   A R C H I V E D   T O P I C
  

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock