I need to confirm my research here on the forum about the Getrag.

I found for sale a Getrag mated to a 3.4 DOHC from a Lumina Z34.
The info I found here says this is a 284 trans which I understand
is not a good replacement for a 282.

??????

Bob

shifter is different
and NOT the same as a FWD 282 so custom cables are needed + or trick work
and the clutch throwout bearing slave is inside the trans, hyd throwout bearing setup
so fab work is need on both

are the mounts the same???
axle size ??
input shaft??

stronger but way more work to use
and no common data base on fiero swaps YET

------------------
Question wonder and be wierd
are you kind?

[This message has been edited by ray b (edited 11-15-2005).]

Check out this thread

https://www.fiero.nl/forum/Forum2/HTML/067657.html

i was gonna say go to that thread ..the one i started ...ya what would u like to know ..because it sounds like ur asking the same question ..ya it seemed like it would be too much work for it ..but i think i can post another link that would help u out too

..let me find it ....

here you go ..starts on pg 11 ...where the swap begins

http://www.fierodrivers.com/forum/index.php?topic=2111.150

i never got in contact with this person ..he lives only 4 hours away and has it all done supposidly ..good luck on whatever your doing

matt