 
     |
| On eBay: Polished Aluminum Trim Rings for the Fiero Instrument Cluster by Dido Tuning (Page 2/2) |
|
jjd2296
|
MAR 02, 04:12 PM
|
|
|
My rings at 3.6 od. The size on my dash is 3.36 inches.
|
|
|
|
jjd2296
|
MAR 03, 11:47 AM
|
|
|
seller is making me another set.
|
|
|
|
reinhart
|
MAR 07, 04:11 AM
|
|
|
If I were going to go this route would want all the openings to match, not just the tach/speedo (e.g. The gas, temp, oil, tach, idiot light openings)
|
|
|
|
ceverhart
|
MAR 09, 12:31 AM
|
|
The set I received are too small, the compression ring would need to be cut pushed out 1/16 of an inch to hold them in place....Glue would probably work but I will not glue them since it is 88 dot matrix.
|
|
|
|
Dennis LaGrua
|
MAR 13, 02:32 AM
|
|
I believe the confusion here is that the Fiero gauge cluster panels were made in two or three different sizes. I found this out when I purchased a set of
"wood" aftermarket dash panel covers. ------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE "
|
|
|
Vintage-Nut
|
MAR 17, 12:23 PM
|
|
Second Set Are Perfect!
The key is to measure your panel ID before ordering, and then inform the seller your 'size'
The thin edge of these rings can be easy 'folded' in the panel to hold them in....
https://www.youtube.com/watch?v=h0ROEy11C5A&t=103s[This message has been edited by Vintage-Nut (edited 11-15-2025).]
|
|
|
|