|
Project "off the Rickst'er Scale" begins (Page 114/117) |
|
exoticse
|
APR 15, 10:09 PM
|
|
|
|
Bozzie
|
APR 17, 05:40 PM
|
|
Hello everybody and thanks for the welcoming Im pretty far into the build but will back it up as much as i can . JB.....that GTM is just ITCHING ME !! Its gonna be a toss between that and Alchemy.... my 512. Not to sure yet. Ok.... updates....
Boz
|
|
|
Bozzie
|
APR 17, 05:42 PM
|
|
Here is the motor.
3800 SC Series II. 43K on the clock. I took the heads off and put on Series III heads with ARP studs. Also deleted the balance shaft and sealed the oil passageway. Put in a Cam and new water pump / gaskets all around. Also ported intake manafold with coolant passageways blocked off. 500 stall higher converter with new flex plate.
Boz[This message has been edited by Bozzie (edited 04-17-2020).]
|
|
|
Bozzie
|
APR 17, 05:46 PM
|
|
Here is my Son installing a new tranny filter and Aluminum Pan. This tranny has 11k on it and is the 329 ratio
Boz
|
|
|
Bozzie
|
APR 17, 05:47 PM
|
|
Noone is safe when they stop in at the shop for a visit !! Put my girlfriend to work on the oil filter
Boz
|
|
|
Bozzie
|
APR 17, 05:50 PM
|
|
Engine on the cradle with tranny attached and mounted. ZZP powerlogs front and back / northstar throttle body, with Wires and full size intercooler ....and harness by James I had him wire it up so the computer is going to be mounted just under the grill on the drivers side.
Boz[This message has been edited by Bozzie (edited 04-17-2020).]
|
|
|
Bozzie
|
APR 17, 05:52 PM
|
|
Zero lash sway bar bushings installed. Motor is coming together....heck ...even put the dog to work !!
Boz[This message has been edited by Bozzie (edited 04-17-2020).]
|
|
|
Bozzie
|
APR 17, 06:04 PM
|
|
With the motor looking good time to bring the car in. Had my Support team with me
Boz
|
|
|
Bozzie
|
APR 17, 06:06 PM
|
|
On the lift. Already did Guru's brakes. Next is SS lines , Guru's rear coilovers . Also going to clean the areas up and por 15 it.
Boz
|
|
|
Bozzie
|
APR 17, 06:08 PM
|
|
In the front time for a rebuild. Cleaning and por 15, new bushings , tie rods , cut springs, ball joints , zero lash sway bar bushings and the passenger side rack bushing....typical !
Yes i know...this is a pic of the rear !
Boz[This message has been edited by Bozzie (edited 04-17-2020).]
|
|
|