!!!~CUSTOM2M4 - A Sneek Peak~!!! (Page 9/34)
Custom2M4 APR 12, 05:23 PM
Ohh yeah I forgot to mention... Page Pwned.

------------------

Custom2M4 APR 12, 06:53 PM
Whilst glassing the first panel, it started melting on me even with the release agent as a barrier.... Sigh, so much for poly foam not melting. It wasn't quick, but still melting, I'm hoping it will still work. We'll see in an hour or so.

[This message has been edited by Custom2M4 (edited 04-12-2006).]

Newbfiero APR 12, 07:00 PM
Custom2M4 APR 12, 07:07 PM
More so like... ...

Guess I am going to have to do it the old fashion way and plaster all the foam plugs.. sigh what a waste.

[This message has been edited by Custom2M4 (edited 04-12-2006).]

The Aura APR 12, 07:31 PM
Just cover the foam board with tape and it won't melt.
Newbfiero APR 12, 07:40 PM
awww am sorry to hear 2m4 about that ..Hope its nothing to bad .and hope can be work around it for your Hard work you put into this .. and sorry for the .I must off miss the post the first time ..Rob
Custom2M4 APR 12, 08:03 PM
Well I obviously have to cover them with something,

Either
- Duct tape
- Tin Foil
- Plaster
etc.

It still sucks though. It was going pretty good for a while, took alot longer then I expected before it actually started to melt. I think the coats of mold release were helping quite a bit, but they were seeping into the foam a little bit. Guess I need to get some more duct tape and foil.

RCR APR 13, 07:41 AM
Shellac the he77 out of it, then put your mold release on. Should work for you...

Bob

Newbfiero APR 14, 07:58 AM
Custom2M4 APR 14, 09:04 PM
Well I decided to break from the fiero for a week. Keeps me on my feet and not angry at different projects.

It needed some new enclosures. I hope to have these finished by this weekend, and then I have a friend that is dropping off some door panels and trunk plates and wants some work done...

Soo expect a delay before the next update.

Thanks guys,
Chase.

[This message has been edited by Custom2M4 (edited 05-18-2006).]