 
     |
| Black Betty Build! (Page 7/53) |
|
BobadooFunk
|
SEP 17, 06:34 PM
|
|
Cleaned em up...
put front one on..
went to put back one on and !!! only one bolt for it!?!? im not sure if i misplaced them.. (i dont think i did..) or if i only had 7..
but i put it there for now ant just started the bolt, then i attatched oil dipstick and bracket
so i searched for the other bolts.. no luck so far.. im thinking i didnt have enuff! anyone have like 6 extra valve cover bolts??
|
|
|
|
Back On Holiday
|
SEP 17, 07:36 PM
|
|
im almost certain i sent all 12 as there arent any holding the valve covers on the donor engine I have sitting, i checked the cleaning solution i threw them in to clean some of the residue off and it was empty also, you might want to double check the blue tape if you havent thrown it out 
|
|
|
|
BobadooFunk
|
SEP 17, 11:10 PM
|
|
ok well they might still be around then! ill double check everything tomorrow when its light out!
so what should i do after valve covers, middle intake, and fuel rail?
|
|
|
|
Formula88
|
SEP 18, 12:17 AM
|
|
|
Yup, middle intake and fuel rail. And the valve cover bolts should be pretty standard, so take one to the hardware store and you should be able to get 'em for a few cents each.
|
|
|
|
BobadooFunk
|
SEP 18, 01:15 AM
|
|
| quote | Originally posted by Formula88:
Yup, middle intake and fuel rail. And the valve cover bolts should be pretty standard, so take one to the hardware store and you should be able to get 'em for a few cents each. |
|
HA oops.. i wrote that post bad..
i meant after those 2 as well.. what should i do?
|
|
|
|
BobadooFunk
|
SEP 18, 03:05 AM
|
|
found em!! in the couch...
Valva covers, lower intake, middle intake, and fuel rail on!
i connected some fuel lines, but not sure which goes to which?? is this right?
where does this go?
i need a picture of what goes in this area.. (besides thermostat housing..)
i am gonna need some MASSIVE help sorting out these lines...
lotsa q's!!!
|
|
|
|
BobadooFunk
|
SEP 18, 03:11 AM
|
|
|
|
|
cptsnoopy
|
SEP 18, 05:16 AM
|
|
this is an oil filter adaptor. It gets two bolts that attach it to the engine block and then you screw the oil filter onto the pipe threads. It should be pretty easy to see where it bolts on if the engine does not already have one on it. 
|
|
|
|
m0sh_man
|
SEP 18, 07:57 AM
|
|
Also its normally easier to put the wiring harness on befor the upper plenum goes into place.
matthew
|
|
|
|
BobadooFunk
|
SEP 18, 03:24 PM
|
|
| quote | Originally posted by cptsnoopy:
this is an oil filter adaptor. It gets two bolts that attach it to the engine block and then you screw the oil filter onto the pipe threads. It should be pretty easy to see where it bolts on if the engine does not already have one on it.
|
|
o i think it already has an oil filter
|
|
|
