88 Coupe gets a 3.4 (Page 38/57)
josef644 JUL 13, 07:44 AM

quote
Originally posted by Marine1981:

Joe, I may be able to get you one of those but not sure. I will let you know.



I have a tilt wheel and pulse wipers. I am thinking that the non tilt wheel is differrent. They are listed as tilt, and non tilt on the data bases of the parts houses.
Marine1981 JUL 13, 11:01 AM
Well I will bring what I have and if you can use it it's yours. It won't take up that much room on the ride.
josef644 JUL 13, 08:29 PM
Bob Hughes is gonna be there tomorrow. I got an E mail from him while I was at work today. He has a nice hood that is only about a 30 min drive from my house here. My hood is trashed.

You need anything? Parts etc?

[This message has been edited by josef644 (edited 07-13-2012).]

Marine1981 JUL 13, 08:38 PM
Not that I can think of at the moment. Maybe an 84 wiring harness. Mind it pretty crispy.
josef644 JUL 14, 07:53 PM
Went to Dickey's Bar B Que in Houston at around 11:30 am. Ben and Becca, Robert Hughes, Cathy, and I were there for about hour and half. Real nice food there today.

Scored me a hood support mechanism, and a windshield wiper switch from Ben.

Back on the car tomorrow am.
josef644 JUL 15, 08:37 PM
I made me a temporary windshield wiper/washer switch today out of a blank plate where the electric trunk release goes. My windshield wiper switch is dead. I used an old wiper switch wiring connector so it just plugs in to the chassis part of the wiring. No permanent damage to my wiring. I have three switches. Lo, Hi and Washer Pump.
Marine1981 JUL 16, 01:44 AM
That's one way to adapt and overcome lol. Did that pump end up working? I believe it was working but the tank was cracked so I replaced it and didn't need the pump.
josef644 JUL 16, 07:44 AM

quote
Originally posted by Marine1981:

That's one way to adapt and overcome lol. Did that pump end up working? I believe it was working but the tank was cracked so I replaced it and didn't need the pump.



The pump was deceased. The switch you gave me does not have washer wires. But it worked good as a wiper. I am not wanting to tear into the top of a tilt steering column.
Marine1981 JUL 16, 12:39 PM
Well I tried, at least you put them to good use. Maybe you can take that pump apart and see if you can figure out how those springs go?
josef644 JUL 19, 05:35 PM
I put The Fiero Store's front windshield moulding on the car a few days ago and forgot to post a pic. It was a perfect fit. I used 3M trim adhesive to attach it in the windshield channel.

[This message has been edited by josef644 (edited 07-19-2012).]