Ah, Success. I was able to do my Case learn, it was actually CKP relearn on the SnapOn Solus Pro I borrowed. As I was getting it up to temp it sprung a pretty good antifreeze leak under the heater core area under the car. Theres not much rust in this car, but it sat for so long that the little things are giving out. I would rather find this stuff out now than on the road.
hercimer01
OCT 20, 02:55 AM
I had an extra heater core I grabbed from LKQ a couple of years ago. That's in and removed the brake line from the front to the rear. Maybe i can get that replaced this week sometime.
hercimer01
OCT 22, 02:57 AM
Yay!!! PIP is back up!!!
I replaced the main brake line from the proportioning valve in the front to the tee by the right rear tire. The bubble flare nuts are M14X1.5 with 6mm tubing. P/N BLF-53C-5 at Autozone. I used a metric double flare tool and made fine looking bubble flares with it.
hercimer01
OCT 22, 04:37 PM
OK so seriously. The hoses are bad and im replacing the rest of the rear lines too. At this rate I will be replacing the whole front system also.
phonedawgz
OCT 22, 05:01 PM
Seriously, you should.
Anything that is in Wisconsin is well rotted to gone by now. Might as well get it all done.
hercimer01
OCT 22, 08:43 PM
quote
Originally posted by phonedawgz:
Seriously, you should.
Anything that is in Wisconsin is well rotted to gone by now. Might as well get it all done.
Yeah, I will. I guess i'm just spoiled, my Formula is from Phoenix and its a joy to work on. NO rust except under the battery a tiny bit.
At least its on the ground and portable now. I used P/N BLF-39C-5 (M10X1, 3/16" tubing) for the small tube fittings in the rear.
[This message has been edited by hercimer01 (edited 10-22-2011).]
hercimer01
OCT 23, 03:11 PM
Try to ignore his annoying gum smack. Its portable now!!
I was sitting on a 4X4 chunk of wood, so it was hard to accelerate right.
[This message has been edited by hercimer01 (edited 12-23-2011).]
hercimer01
NOV 05, 05:55 PM
I have a 4K RPM stumble now with no codes. I did a CASE learn with a SnapOn Solus Pro scantool after I installed the PCM. I dont know if it has been doing this all along or just started. I haven't had the car out yet for a hard drive, just around the block. Anyone have any ideas whats causing this?
[This message has been edited by hercimer01 (edited 07-07-2012).]
phonedawgz
NOV 05, 06:01 PM
Rev limiter in Neutral.
hercimer01
NOV 05, 06:03 PM
Thanks I was wondering about that.
[This message has been edited by hercimer01 (edited 07-07-2012).]
