Chop Top #18 G6 Install (Page 2/15) rodneybooth OCT 29, 08:00 PM Stuff taken out so far...the trash pile gets bigger New lid shock installed and bigger! madcurl OCT 29, 08:11 PM Sweet! rodneybooth OCT 30, 07:17 AM This is firewall before we started. Not very nice. Reminds me of my sister's closet. Firewall with the panel templates made Sheet metal panels made but need to be painted and mounted rodneybooth OCT 30, 02:15 PM Rerouted the wires and installed them in wire looms just like the picture says Now we have a smooth firewall! The engine bay is ready and now on to the tranny swap madcurl OCT 30, 02:23 PM Sweet! The next engine swap, I too would like to have engine bay cleaned up a bit. You're providing an excellent example. fieroguru OCT 30, 05:30 PM Looks very good. I can appreciate all the work cleaning up the firewall takes. Here is stage 2 of my firewall cleaning: http://www.fiero.nl/forum/Forum2/HTML/083056.html This winter I will be doing more firewall upgrades as I upgrade to the G6 6 speed along with several other engine mods. rodneybooth OCT 30, 05:57 PM Thanks Curly. A complement from you goes a long way. Guru, I like the crhome look. rodneybooth OCT 30, 06:25 PM Uh oh, looks like the intake is leaking at the front Uh oh, distributor trouble. The distributor rotor button needs to be replaced. Now I understand my loss of power. Uh oh, the distributor cap needs replacing too!!! Nasty!! The top of the engine all looks good rodneybooth OCT 30, 07:57 PM I looked for the thread on Fieros in the Fall and couldn't find it. So these are some I took today. It is the first set since all the "current" work. rodneybooth OCT 30, 08:41 PM A look at the G6 F40. Not an expensive gearbox but newer technology the original 5 speed Getrag. I could pull stumps with first gear. I don't have a good shot of the Quaiffe LSD (which was 4 times the cost of the tranny) but it was a direct fit. We sent it out to a tranny pro to make sure it would be right