Fiero CAD (Page 1/1)
zoomie_gt SEP 03, 09:38 PM
Okie dokie gents. I am underway on an admittedly incredibly ambitious design. I'm looking to mount a non-M-family supercharger to a 3.4 OHV I am currently rebuilding, and it isn't centrifugal either. The issue is that I will need to create a custom spacer to adapt the charge outputs of the supercharger to the intakes of the middle intake manifold. I can measure it all myself, but I was wondering if anyone had already done the legwork themselves. Of for that matter, done any CAD on any of the belt system for the Fiero either.

Also, the supercharger is the Eaton TVS R1320. Yes yes, I know it's far from the easiest choice here or maybe even the best choice. However, I want to do this and I believe I have the engineering muster to make it happen. I will be doing the necessary improvements to the OE parts in the rebuild to ensure it doesn't blow up (immediately) on me. However, I can't get around to blowing up the 3.4 unless I can actually mate the supercharger . Any and all CAD for the fiero 2.8 or the 3.4 OHV, but mainly the information I mentioned at the beginning, would be very appreciated. Whatever CAD I collect and make I will post here as I build this.
Thanks!
Dennis LaGrua SEP 04, 02:16 AM
That axial supercharger should work very well on a prepped 3-4 liter engine and it has been used with electric clutches to save power when cruising at steady speed. It is capable of making considerable boost so an air water intercooler would likely be required. Best of luck on the project.

------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE "