84-88 Coolant Expansion Tank Cap - Is there supposed to be a valve in there? (Page 1/2)
Brian A AUG 13, 10:15 PM
Is the coolant expansion tank cap supposed to have a valve in it?

When I blow on mine, the air just passes through unencumbered. I have no valve of any sort. It seems odd that the coolant system is open to the atmosphere. Mine spits coolant under aggressive driving (i.e. on the track).

Attached is a picture of the cap to which I am referring (courtesy of the Fiero Store):


Patrick AUG 13, 10:21 PM
.
There is no valve. The coolant level goes up and down during every heat cycle. Neither is pressure or a vacuum desirable in the Fiero's coolant reservoir.

[This message has been edited by Patrick (edited 08-14-2026).]

Vintage-Nut AUG 13, 10:39 PM

quote
Mine spits coolant under aggressive driving (i.e. on the track).



1st - Check the coolant expansion tank level when HOT
2nd - The tank has "ADD" and "FULL" level lines

My suggestion is lowering your coolant expansion tank level near the "ADD" line at the track.... not at the "FULL" line
Brian A AUG 14, 12:38 AM
Got it. Thanks.

I will lower the level a little to give more room for slosh.
fierosound AUG 14, 11:30 AM
I changed my overflow tank cap out for a different one.
Still vents properly, but coolant won't splash through.


------------------
My World of Wheels Winners (Click on links below)

3.4L Supercharged 87 GT and Super Duty 4 Indy #163

Frenchrafe AUG 14, 12:23 PM
So you seem to be loosing coolant and washer fluid on the track, according to your recent posts?

For the washer, just don't fill it up too far! You don't need to carry those litres/kg of fluid on a track day. (Or any time if your car isn't a daily driver.)

For the coolant, verify that your radiator pressure cap is OK? I've had a bad one that would work fine on normal driving and then let go on a trackday!
The coolant overflow tank would then "overflow"! The extra heat (and pressure) in the engine, made by hard circuit driving, would pop it.

Cheers,
Rafe

------------------
"Turbo Slug" - '87 Fiero GT. 3800 turbo. - The fastest Fiero in France! @turboslugfiero
https://youtu.be/jabDuMyJvrM

82-T/A [At Work] AUG 14, 02:06 PM
I've had the same problem with my daughter's Fiero.

She drives it like someone else's grandma (because my grandmother always floored it in her LTD). But when I drive it, I'm really tossing it in the turns, and when I come back, I always see a little bit of coolant on top of it. Since the entire front of the car looks like a brand new car... it gets her mad when she sees even a little bit of coolant on the top.

It's just because the cap is designed to vent, but doesn't really do a good job of stopping coolant from coming up and out when it sloshes around. More expensive cars of the time, like the C4 Corvette had baffles in the overflow tank. But in our car, it's basically the same design you'd see on a Cadillac... which no one is tossing into turns.

I'm interested in that DORMAN cap that Fierosound posted... but I know my daughter would not go with something that isn't totally stock looking. But I wonder if there's some way to put a small thin mesh around the opening between the cap and the container... just to stop the slosh... @patrick, kind of like what you recommended in the valve cover of the Duke for the PCV (which we did, and haven't seen any more oil come through the PCV tube).


EDIT: I'm thinking something like this: https://www.amazon.com/Stai...ainer/dp/B0CLB5Y2B5/




Ok, just measured the overflow cap. It's roughly ~45mm. The only thing, the bottom of the cap protrudes into the overflow tank, so a 45mm wouldn't realy work unless you stretched it. I'm going to buy one just for the hell of it, and see how it works.

I also noticed that the cardboard gasket that comes with the cap, failed miserably. It basically deteriorated, and the cap likely needs a seal that's made of thin neoprene. I half wonder if the leak is because the cardboard gasket has failed, and not because it's leaking out through the vent holes? Just bought this: https://www.amazon.com/DEFA...Thick/dp/B0H369DZSQ/ ... 45mm OD, 35mm ID, and 2mm thickness.

I'll respond to your response in the windshield one.

[This message has been edited by 82-T/A [At Work] (edited 08-14-2026).]

Brian A AUG 14, 07:04 PM



quote
Originally posted by fierosound:

I changed my overflow tank cap out for a different one.
Still vents properly, but coolant won't splash through.



Interesting. I might buy one to try it out.



quote
Originally posted by Frenchrafe:

For the coolant, verify that your radiator pressure cap is OK?




That is a good suggestion: I have never tested or replaced my cap.


quote
Originally posted by 82-T/A [At Work]:

More expensive cars of the time, like the C4 Corvette had baffles in the overflow tank. But in our car, it's basically the same design you'd see on a Cadillac... which no one is tossing into turns.





... and the system allows the coolant system to take a nice breath of fresh oxygenated air with each coolant expansion cycle to facilitate corrosion in the engine.

There are better designs. My other rear-mid car has the expansion tank in back and is made of metal. Coolant continually circulates through the tank. It is filled only 1/3 full to accommodate liquid expansion. The air compresses. The tank has the 16 psi "radiator" cap on it. It has an overflow to the ground should the car overpressure above 16 psi. And has a one-way air valve should the system pull a vacuum. (Stant 10230).




Patrick AUG 14, 07:19 PM

quote
Originally posted by Brian A:

There are better designs. My other rear-mid car has the expansion tank in back and is made of metal. Coolant continually circulates through the tank. It is filled only 1/3 full to accommodate liquid expansion. The air compresses. The tank has the 16 psi "radiator" cap on it. It has an overflow to the ground should the car overpressure above 16 psi. And has a one-way air valve should the system pull a vacuum. (Stant 10230).



What type of car does that fancy expansion tank come in? Obviously a much more expensive vehicle than a factory "econobox" Fiero.

What the Fiero has is better described as a coolant reservoir and/or an overflow tank. Although yes, there are "better designs", it's cheap and does what's required.
Brian A AUG 14, 10:58 PM

quote
Originally posted by Patrick:

What type of car does that fancy expansion tank come in? Obviously a much more expensive vehicle than a factory "econobox" Fiero. .



I suppose. It's a 1983 Ferrari 308 GTS Quattrovalvole.

The only time I experienced dejection with it was when I took it to a Fiero Club meeting. Everyone got all excited "Oooo! Oooo! Look a Mera! I've never seen one before! ... oh, wait a minute ... darn ... it's real."

[This message has been edited by Brian A (edited 08-14-2026).]