

 |
Cruise Control with 3.5 v6 4T65E conversion (Page 1/1) |
|
Cajun
|
MAR 10, 04:06 PM
|
|
For those of you that have done or considering doing this swap, what have you done or doing to address cruise control?
I am currently in the process of hi-jacking the BCM that comes standard with a 2010 Chevy Impala.
Also, I am planning on utilizing the stock Fiero 86 GT cruise control stalk. I think I have work out the electrical aspects of that conversion?? Basically, just a matter of adding resistors between the various switch positions.
Thank you in advance for your response and feed back.....
|
|
|
olejoedad
|
MAR 10, 07:05 PM
|
|
Go to gmtuners.com, Ryan has that information on the website.
Use a digital cruise box and wire it per his instructions.
The only signal the DCC needs is the 4000ppm speedo signal from the ECM, otherwise its powers and ground, a relay and inputs from the CC stalk.
|
|
|
Cajun
|
MAR 13, 08:47 AM
|
|
Yeah, that's not going to work.
I have been in contact with Ryan. He tuned the ECM & PCM for my swap.
The cruise controller needs to be capable to "drive by wire".....
I was looking for information what others have done to address Cruise control for their swap.
|
|
|
olejoedad
|
MAR 13, 10:14 AM
|
|
Well, Ryan would be the go-to guy for advice.
I didn't realize your setup was drive by wire.
Let us know how you figured it out!
|
|

 |
|