Terminal removal tool (Page 1/1)
steve308 APR 27, 08:09 AM
Saw this on facebook.

brilliaire.com/products/terminal-removal-tool-kit
theogre APR 27, 09:48 AM
Likely works on many things... Don't count on it to remove GM parts for Weather Pack and Metripak Pull-to-Seat.

I have many term tools over many years and WP is "odd size" vs Molex and many others using tube tools to release.
M PtS basically uses a very small sharp "screw driver" type tool but terminals Do Not pull out of the back of shells. These are use on DIS, OP sender and more starting in ~ '87.

Lisle like PN 14900 and others make tools for WP but tolerance used by them may not fit too because female terms can wallow out w/ idiots beating the hell out of them etc. 14900 doesn't fit M PtS terms and most other Metri Pak ends because design for older GM vehicles before GM made this type ends. Don't think Lisle's blue or silver tools fit them either.

Many other GM ends release w/ stiff wire or small screw driver.
Example: See my Cave, Defect & Connection notes
That bent paper clip tool/trick releases many ends like HL bulb plugs.

------------------
Dr. Ian Malcolm: Yeah, but your scientists were so preoccupied with whether or not they could, they didn't stop to think if they should.
(Jurassic Park)

The Ogre's Fiero Cave

Dennis LaGrua APR 27, 08:00 PM
If it is the circular KD tool with a number of different size pins on it; I've never had a connector pin that I could not remove with it.

------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE "