spoiler hardware (Page 1/1) kevinl85f OCT 03, 07:17 PM Where can I find the hardware to bolt the spoiler fin to the posts? Any suggestions? Thanks, kevin fierofool OCT 03, 09:48 PM There is a rubber insert that goes into the spoiler. Called Well Nut. The Au-Ve-Co number I have is 16248 and the size is M5 - 8 Range .035 - .232 in. You will need PanHead screws to fit into the countersink of the wing stand in order to prevent breaking the wingstand. I recommend brass or stainless screws and a little never seize on them in case future removal is needed. Fastenal sells Well Nuts by various manufacturers. Grainger should also have them. I bought mine at an automotive paint and body supply but I had to wait for them to order them in. Fastenal had them on hand. I also have a Well Nut number 8832. Range .38 - 3.96 mm. These are larger and I don't believe they're the ones I've used for the spoiler. vette7584 OCT 07, 10:03 AM i have what you need, i sent you a pm with my contact info 1987 Trans Am NOV 24, 05:22 PM I too am in need of hardware for the spoiler. Both for stand to spoiler and stand to decklid kevinl85f NOV 26, 02:41 PM I used well nuts from vally fastners, I was forced to oversize the holes in spoiler due to rusted and siezed connectors. the post above should provide you a start to find your fix, good luck and good results