 
     |
| OPPINIONS ON THESE PULLIES ? (Page 1/1) |
|
Lou6t4gto
|
MAY 20, 07:30 PM
|
|
|
|
Dennis LaGrua
|
MAY 20, 10:03 PM
|
|
A 3.5" pulley on a series II engine can be used with very slight mods BUT you will need a specially made expensive puller to remove and install it.
------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE " [This message has been edited by Dennis LaGrua (edited 05-20-2019).]
|
|
|
Lou6t4gto
|
MAY 21, 12:00 AM
|
|
|
already found that out. impossible to pull with a 2 prong or 3 hole steering wheel puller with a" plate" behind it. might be cheaper to just take the blower to a machine shop and let Them pull it !
|
|
|
|
Lou6t4gto
|
MAY 24, 07:30 PM
|
|
|
Well, I "MADE" a Puller, and successfully got 2 pulleys off. but I'm here to tell ya, it BENT a 1/2 inch steel plate doing it ! a Bench press is your best friend on this. LOL
|
|
|
|