 
     |
| cold start valve (Page 1/1) |
|
tazome
|
MAR 27, 10:24 PM
|
|
|
Hey guys can anyone tell me were i can get the steel/rubber was her that fits on the cold start valve, i bought the o ring kit from the fiero store but it didn't come with one, i check the local napa, auto autozone , ace an even the gm dealer? no luck any ideals? thanks 87 2.8 liter [This message has been edited by tazome (edited 03-27-2018).]
|
|
|
|
Spoon
|
MAR 27, 11:38 PM
|
|
Not sure what your asking for... steel/rubber??
Here's the whole setup on ebay.
https://www.ebay.com/itm/Fi...5738.m4383.l4275.c10
Spoon------------------
"Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut
|
|
|
|
Gall757
|
MAR 28, 09:42 AM
|
|
|
|
|
tazome
|
APR 02, 09:07 PM
|
|
|
it looks like the shader valve seal, but the cold start injector has one just like it where the injector screws in to the manifold, im gona call the fiero store to see if its the same one an size
|
|
|
|
sledcaddie
|
SEP 23, 05:27 PM
|
|
|
Did anyone ever find anything out about this? It's the cold start valve fitting that goes on the fuel rail side. There is no O-ring, as shown on the Fiero Store illustration. It has a 19mm metal washer with a rubber ring on the I.D. It does look similar to the shrader valve gasket. Did you find anything out from the Fiero Store? Will the shrader valve gasket work? (I just dropped the one I had while I was measuring it, and now I can't find it!)
|
|
|
|
sledcaddie
|
SEP 24, 09:57 AM
|
|
|
|
