84-87 12" Corvette Brake Swap... (Page 22/28) Shianne AUG 14, 09:40 AM One last question? Does it make a difference weather the caliper is on the right or the left. It would be nice to have the bleed screw facing down. From what I can see it does not make a lot of difference to caliper position in relation to the bracket. With the calipers mounted as marked it would place the bleed screw facing up. I have not paid attention to the late 80's earlier 90's vettes to know how there's are mounted but I assume the caliper is on the front of the front rotor not on the rear as our conversion has it. got the rears done, got the hubs back on with new studs, just have the master cylinder and front calipers to mount then out to try it out. Thanks Pat fierodustin AUG 14, 06:20 PM You will want your bleeders up. You will pull your hair out trying to bleed them if you mount them down. Dustin Shianne AUG 14, 07:11 PM Thanks for that if it ever stops raining here I will get them finished up. ace5514 JAN 05, 01:37 AM anything new on this setup. it looks interesting and not ultra expensive. al Fierofreak00 JAN 05, 12:40 PM Have all the parts...still waiting on someone to make the brackets. -Jason Jncomutt JAN 05, 02:02 PM The car came with 9" brakes. These are 3 inches larger than stock. Yes, there will be some issues trying to get that extra inch and a half of clearance. Put a jack under a control arm and see how much of an issue that banjo is. I really hope you're not planning on jumping your car with the wheel at full lock. The solution to this problem is to weld the lower shock mount higher up on the control arm. Jncomutt JAN 05, 02:04 PM quote Originally posted by Fierofreak00: Have all the parts...still waiting on someone to make the brackets. -Jason I'm working on carrying brackets, rings, and modified control arms in my webstore. I'll update this thread If/when I get some done. Fierofreak00 JAN 05, 04:45 PM quote Originally posted by Jncomutt: I'm working on carrying brackets, rings, and modified control arms in my webstore. I'll update this thread If/when I get some done. You sir...will be my hero! I can't tell you how many times I have given the drawings to people only to have them not come thru.... -Jason mera7 JAN 06, 12:50 AM sorry to jump in on this thread but i have a new set 4 of these rotors cross drilled for sale if anyone is interested. mike in oklahoma pm me Austrian Import JAN 18, 04:55 PM What do you guys think this swap would cost alltogether. (including the small nickel&dime stuff, i.e.: hoses, bolts, nuts, brake pads, etc.)