The Turbo 3500 F23 swap (Page 20/80)
ericjon262 MAR 06, 11:41 AM
thanks, waiting on parts right now, hopefully once they are here I can get some real progress going again...
fieroaddicted MAR 06, 08:25 PM
ericjon262 MAR 13, 10:20 PM
.

[This message has been edited by ericjon262 (edited 09-11-2022).]

Slowbuild MAR 14, 10:51 AM
RE: Expansion joints.

I had the same trouble with space on my twin scroll mitsu setup with a 3.4. What I figured was that if my front bank had a joint, my wastegate takeoff had an expansion joint, and my downpipe could move (which it can, it's just hung on exhaust hangers, then the rear bank can expand and not cause stress.

In othere words, if you stress relieve all except one, then that one can be free to move.

So far there has been no problems.

I wrapped with DEI titanium and the transaxle is fine so far. Be very carefull with heat around the shift cable ends...they get soft and slip off the ball studs.

Chay

[This message has been edited by Slowbuild (edited 03-14-2013).]

ericjon262 MAR 14, 07:29 PM
.

[This message has been edited by ericjon262 (edited 09-11-2022).]

ericjon262 MAR 18, 10:33 PM
.

[This message has been edited by ericjon262 (edited 09-11-2022).]

ericjon262 MAR 21, 10:50 PM
.

[This message has been edited by ericjon262 (edited 09-11-2022).]

ericjon262 MAR 25, 06:43 PM
.

[This message has been edited by ericjon262 (edited 09-11-2022).]

ericjon262 APR 01, 11:57 PM
.

[This message has been edited by ericjon262 (edited 09-11-2022).]

ericjon262 APR 03, 02:17 AM
.

[This message has been edited by ericjon262 (edited 09-11-2022).]