 
     |
| 88 fiero formula awful gas milage (Page 2/2) |
|
Kyle88formula
|
MAY 09, 09:58 AM
|
|
| quote | Originally posted by Patrick:
Is the entire stainless steel factory exhaust rotten (very doubtful), or is it just the short mild-steel lengths of pipe on either end of an aftermarket cat that have rotted?
|
|
C
|
|
|
|
Kyle88formula
|
MAY 09, 10:00 AM
|
|
| quote | Originally posted by Patrick:
Is the entire stainless steel factory exhaust rotten (very doubtful), or is it just the short mild-steel lengths of pipe on either end of an aftermarket cat that have rotted?
|
|
Cat is fine, headpipe is blown out on one side and the pipe leaving the cat is blown out too. Muffler has also split on the side facing the trunk.
|
|
|
|
Dennis LaGrua
|
MAY 09, 10:27 AM
|
|
| quote | Originally posted by Kyle88formula:
Cat is fine, headpipe is blown out on one side and the pipe leaving the cat is blown out too. Muffler has also split on the side facing the trunk. |
|
Poor fuel mileage can be caused by a dozen reasons. clogged cat, defective O2 sensor (or other sensors), stuck open injector, defective thermostat, leaking cold start injector, ignition problems (or miss), and severe engine wear. The only way to tell is by doing all of the checks item by item.------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE "
|
|
|
|
Forrest
|
MAY 09, 11:31 AM
|
|
Hey Kyle....my sons 88 fiero got 11 mpg as well. It was terrible. We found out that one of the injectors was bad. I replaced the broken one and cleaned the rest. This got him up to around 13-14 mpg.
I did a coolant flush due to the crazy cold snaps we have been getting down here in Texas and not wanting his new radiator, and heater coil to splode cuz we had water in the system.
While doing this I noticed there was no thermostat in the car (it was missing in my 86 as well....weird). Anywho I replaced it and the car gets to operating temp WAY faster. On cool days the heater would normally not work until I got where I was going.
The car was staying in warm up (rich) mode basically for the entire drive....every drive. After replacing the thermostat I regularly get 15-17 mpg with a light foot and I guess around 20 highway.
Maybe something to check.
BTW I enjoy your videos. Keep up the good work.
|
|
|
|
theogre
|
MAY 09, 11:32 AM
|
|
| quote | Originally posted by Dennis LaGrua:
Poor fuel mileage can be caused by a dozen reasons. clogged cat, defective O2 sensor (or other sensors), stuck open injector, defective thermostat, leaking cold start injector, ignition problems (or miss), and severe engine wear. The only way to tell is by doing all of the checks item by item. |
|
Add Iffy ECT or wires to it.
ECT was upgraded to Metripack plug (88 should have the upgrade) because old plug was giant pain and can a lot of headaches.
See my Cave, Sensors Quick Ref
|
|
|
|
Dennis LaGrua
|
MAY 09, 01:19 PM
|
|
|
Do you have access to a scan tool?? Any codes showing? To check for a blown injector , secure a fuel pressure gauge an attach it to the schrader valve fitting on the fuel rail. At idle the pressure should be around 43.5 PSI. If the pressure drops quickly when you turn the engine off that indicates a fuel injector or cold start injector problem. If all is good then check the ETS/CTS sensor. Only a scan or a resistance check in hot water will check it. IMO, those are two of the most likely possibilities ------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE "
|
|
|
|
Raydar
|
MAY 11, 10:12 AM
|
|
Dennis beat me to it.
If you have access to a scan tool, look at the Coolant Temp (CTS) and the Intake Air Temp (IAT) readings. Look for anything that seems to be "too cold". (CTS should reflect reasonable engine temp. IAC should be "ambient" air, or maybe a bit warmer.)
These will be separate sensors from your gauge sender. The gauge will not be an accurate representation of anything but the gauge sensor reading.[This message has been edited by Raydar (edited 05-11-2022).]
|
|
|
|