Very little pressure at clutch pedal (Page 2/2)
Addition1291 SEP 16, 08:21 PM
Update.

Long Story Short: New Master, new Slave, new slave bracket. I got the lines all hooked up and bled too. I still am not getting pressure.

I was looking at it today while my friend was depressing the clutch, and I noticed that the slave wouldn't move. Then I noticed that the reason the slave wouldn't move is because the clutch arm on the transmission is too far back maybe? I can pull it forward, but not push it back, which leads me to believe that the clutch arm is stuck in the engaged position? If I pull it forward, and the clutch pedal is pressed, there is pressure at the pedal but not normally.

Any ideas?

[This message has been edited by Addition1291 (edited 09-16-2019).]

Addition1291 SEP 17, 03:58 PM
Final update:

I looked online and found Archie's bleed procedure, which involves compressing the slave cylinder. Solved my problem! Its driving again.