 
     |
| Post your Ideas for New Fiero Parts here. (Page 1/3) |
|
Dennis LaGrua
|
APR 01, 05:37 PM
|
|
Years back the aftermarket for custom and standard Fiero parts was a decent size. As the car grew older the parts market became more specialized and some vendors dropped out of it. Judging by the activity on this forum it appears that there is still a market for Fiero parts. I started this post to give vendors and potential vendor a idea of what might be needed. In short the title should be "I'd like to see"
My suggestions:
One piece C4 taillight panel.
Mecham style side scoops.
Swap mounts for the LFX engine and 6T70 transmission.
Custom axles for the above.
Plastic Glovebox re-run.
Bracket for trunk mounted battery.
Add your idea's and if there is a demand, perhaps someone will make the parts.
------------------
" THE BLACK PARALYZER" -87GT 3800SC Series III engine, custom ZZP /Frozen Boost Intercooler setup, 3.4" Pulley, Northstar TB, LS1 MAF, 3" Spintech/Hedman Exhaust, P-log Manifold, Autolite 104's, MSD wires, Custom CAI, 4T65eHD w. custom axles, Champion Radiator, S10 Brake Booster, HP Tuners VCM Suite.
"THE COLUSSUS"
87GT - ALL OUT 3.4L Turbocharged engine, Garrett Hybrid Turbo, MSD ign., modified TH125H
" ON THE LOOSE WITHOUT THE JUICE "
|
|
|
|
Kitskaboodle
|
APR 02, 10:57 AM
|
|
Darrel Morse style rear strut brace
Vent wing hold down butterfly screws
88 only alternator shield
Kit
|
|
|
|
lorennerol
|
APR 02, 11:36 AM
|
|
|
Center console skeleton made from a tougher (less brittle) material.
|
|
|
|
Raydar
|
APR 02, 04:54 PM
|
|
Swap mounts and axles for the F40.
Edit - R.T. is doing mounting brackets. Still need a simple axle solution.[This message has been edited by Raydar (edited 04-08-2019).]
|
|
|
|
tshark
|
APR 02, 07:26 PM
|
|
Yes, a more sturdy version of the PISA glove box would be great. Or, a revisit of Paul Vargyas' glove box. Either way, it needs to match the interior better.
I just need parts other than the seats.
|
|
|
|
cmechmann
|
APR 02, 08:38 PM
|
|
|
The Pontiac style ram air side scoops.
|
|
|
|
Habanera Hal
|
APR 02, 09:20 PM
|
|
|
Any T-Top plastic parts . Could be done with 3D printer.
|
|
|
|
viperine
|
APR 02, 11:35 PM
|
|
A non-magnetic chick magnet. None of them stick to any of my Fieros 
|
|
|
|
turbo86se
|
APR 03, 07:58 AM
|
|
|
88 cradle to 87 strut frame adapters.
|
|
|
|
mmeyer86gt/gtp
|
APR 03, 01:31 PM
|
|
|
|
|