|
90mm Headlight Bucket Conversion. How do you adjust & aim the headlights? (Page 2/2) |
|
cmechmann
|
NOV 13, 11:34 PM
|
|
I see that you are using LEDs. I recognize the yellow/gold ones. How well do they work down the road on the high beams. I am using 60mm Hella low beam modules and EOE( an Asian OEM manufacturer). Of course the Hellas are 9005. The EOEs are H1. The LEDs I am using on the high beams have CSP leds. While bright, don't seem to cast far enough down the road. But I do still have to tweak them in the housings a little. The pattern is very good. The pattern was good out of the box. But I think I can tweak them to cast further down. I still have halogens in the low beams. What are you using in your low beams?
|
|
|
JohnWPB
|
NOV 14, 04:27 PM
|
|
I honestly do not know how far the high or low are casting at this point. I have yet to take the above advice and go attempt to adjust them. I have a few other projects currently, and have not touched the Blue Fiero in a couple weeks.
|
|
|
MikeyDub89
|
NOV 13, 03:37 PM
|
|
Good morning Fiero Community,
I recently purchased a Low-Profile 60mm headlight bucket kit from Mr. Danyel Potvin. I put together the buckets, but I am having a hard time with the wiring of the headlights. It came with a wiring harness, but I am unsure how it is run. I have tried to contact him regarding installation but no luck. If anyone has pictures of the installation or any guidance on how to, would be greatly appreciated.
V/R, Mike
|
|
|
Easy8
|
NOV 14, 08:21 PM
|
|
Mike, Just installed a set of these last month. Mine needed power (the long red wire) grounds (the 4 black wires) and you plug the plug on the harness into your car. I can take some pics but I wired mine a little different (cut out the plug since my car did not have the other side) I may even have the directions around here some where....
|
|
|
MikeyDub89
|
NOV 15, 11:45 AM
|
|
Thank you very much! Anything will help, and yes if you could provide photos of installation or your methods would be great.
V/R, Mike
|
|
|
skywurz
|
NOV 15, 08:27 PM
|
|
I was going to recommend you start your own thread instead of hijacking a 2 year old dead thread.
I just installed these too i ran a cable from the batt to the headlight harness and plugged in .
|
|
|
Easy8
|
NOV 16, 05:48 PM
|
|
Here are the shots of my install. A couple of the basic install.
Here is where I installed the relays that are part of the harness.
And finally I installed grounds on each side
As I said I cut out the connector that was included since my car had a different headlight set up already. I just spliced the wiring to the car harness.
|
|
|
RichLo1
|
NOV 30, 08:59 AM
|
|
Haha, I just PMed Daniel about this. It seems like I am missing the plastic inserts that the ball end of the screws goes into. Where can I buy those?
|
|
|