Pennock's Fiero Forum
  The Mall
  FS: Clutch arm 4 spd 86

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
FS: Clutch arm 4 spd 86 by Spoon
Started on: 06-22-2020 07:04 PM
Replies: 0 (33 views)
Last post by: Spoon on 06-22-2020 07:04 PM
Spoon
Member
Posts: 3419
From: Sadsburyville, PA. 19369 / USA
Registered: May 2004


Feedback score:    (16)
Leave feedback





Total ratings: 59
Rate this member

Report this Post06-22-2020 07:04 PM Click Here to See the Profile for SpoonSend a Private Message to SpoonEdit/Delete MessageReply w/QuoteDirect Link to This Post


I did a 3800SC swap and made my old clutch arm nice and pretty. Only to find out the tip at the top would not clear the header crossover pipe without grinding off about 3/8'. So I found a boneyard arm to use instead and it did not get the treatment this one got.

So I'm asking $40 shipped within the CON-US

spoon

------------------
"Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut

IP: Logged
PFF
System Bot



All times are ET (US)
next newest topic | next oldest topic

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock