Pennock's Fiero Forum
  The Mall
  1988 Fiero specific parts

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


next newest topic | next oldest topic
1988 Fiero specific parts by sspeedstreet
Started on: 04-26-2014 10:37 PM
Replies: 0 (135 views)
Last post by: sspeedstreet on 04-26-2014 10:37 PM
sspeedstreet
Member
Posts: 2256
From: Santa Maria, CA
Registered: Dec 2002


Feedback score:    (18)
Leave feedback





Total ratings: 53
Rate this member

Report this Post04-26-2014 10:37 PM Click Here to See the Profile for sspeedstreetClick Here to Email sspeedstreetSend a Private Message to sspeedstreetEdit/Delete MessageReply w/QuoteDirect Link to This Post
Motor mount bracket (V6) modified to bolt to a 3.4DOHC. A longer tab was added to reach an additional mounting hole. This could be removed for a non-3.4DOHC installation. This part is satin black powder coated. There are several scratches in the finish down to the metal. This is a California car part (no rust, ever). $85.00 shipped to the lower 48 states.





Getrag transmission mounts, unmodified. These parts are satin black powder coated. There are several scratches in the finish down to the metal. These are California car parts (no rust, ever). $45.00 shipped to the lower 48 states.



Cat-back stainless steel exhaust pipe from a 2.00" Borla exhaust system. No muffler. The pipe opens to 2.25" at the double stainless flange with welded in place nuts at the cat end. A slip joint with clamp is at the muffler end. $125.00 shipped to the lower 48 states.







Neil
IP: Logged
PFF
System Bot



All times are ET (US)
next newest topic | next oldest topic

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



Copyright (c) 1999, C. Pennock