What size of the tap to chase the threads on the block for the cylinder heads

Click here to visit The FieroStore | View all sponsors

Pennock's Fiero Forum

Technical Discussion & Questions

Email This Page to Someone! | Printable Version

next newest topic | next oldest topic

What size of the tap to chase the threads on the block for the cylinder heads by Zentaury

Started on	: 06-19-2020 01:46 PM
Replies	: 1 (87 views)
Last post by	: Gall757 on 06-19-2020 03:56 PM

Zentaury
Member

Posts: 70
From: Vancouver, BC, Canada
Registered: May 2019

Feedback score: N/A
Leave feedback

Rate this member

Report this Post06-19-2020 01:46 PM

Hello,

I am going to put back together my 1985 Fiero GT 2.8L.

Before I had planned to rent a set of taps in the local store but due to the pandemic they are not renting for now.

I have to buy the tap but I don’t want to choose the wrong one.

I looked the FSM, Haynes and Chilton but they only tell you to chase the threads and that’s it.

I guess is related with the bolts that I will use, but I don’t know much about it.

Thanks!

IP: Logged

PFF

System Bot