Pennock's Fiero Forum
  Technical Discussion & Questions
  Custom Polyurethane Bushings DIY

Post New Topic  Post A Reply
Email This Page to Someone! | Printable Version


 next newest topic | next oldest topic
Custom Polyurethane Bushings DIY by Joseph Upson
Started on: 02-09-2020 08:16 PM
Replies: 0 (147 views)
Last post by: Joseph Upson on 02-09-2020 08:16 PM
Joseph Upson
Member
Posts: 4951
From:
Registered: Jan 2002

Feedback score: (2)
Leave feedback





Total ratings: 88
Rate this member
Report this Post02-09-2020 08:16 PM Click Here to See the Profile for Joseph UpsonSend a Private Message to Joseph UpsonEdit/Delete MessageReply w/QuoteDirect Link to This Post
I just found out about this in a discussion about drive shaft center support bearings. Some might find it useful in making mounts, particularly for custom engine and transmission installs. Some may already be aware of it, however, it's new to me.

Reoflex 40 and 60. The demo results look pretty good, with room for improvement depending on the level of perfection desired. I would certainly have used it.

https://www.youtube.com/watch?v=2_0BYvTkZ0o
IP: Logged
PFF
System Bot



All times are ET (US) 		next newest topic | next oldest topic

Post New Topic  Post A Reply
Hop to:

Contact Us | Back To Main Page

Advertizing on PFF | Fiero Parts Vendors
PFF Merchandise | Fiero Gallery | Ogre's Cave
Real-Time Chat | Fiero Related Auctions on eBay



 Copyright (c) 1999, C. Pennock