It appears to be a step by step process of syncing the new system.
Testing Procedures for Sequential Turn SignalsAfter installing your WebElectric sequencers, BEFORE you put the car back together, perform the following procedure:
- Make sure the car's engine and all lights have been off for at least 5 minutes.
- Start the car and let it run. It is important for the electrical system to be fully energized in order for the electronics in the sequencers to sync properly.
- Turn on the left signal and let it run for 1 minute.
- Turn on the right signal and let it run for 1 minute.
- Turn off all signals and stop the engine. Allow the car to rest for 5 minutes. (Now's a good time to get yourself a beer).
- Start the car again and test the signals. If the lamps are not sequencing, or are sequencing very, very fast, or one or more of the lamps are not coming on, double check your installation.
------------------
Mark
' 85 2m6 3.4PR
In the Great Northwest!
[This message has been edited by NW-Fiero (edited 07-14-2015).]