Does anybody happen to know the diameter of the motor pellets (otherwise known as bushings or pins inside the gear of the headlamp motors? This is the 1987/88 motor not the early one.I am over the pond in England and rather than wait two or three weeks delivery I thought I would quickly make some having a lathe and delrin bar in stock. Unfortunately mine are either badly distorted or turned to grit so cannot be used as a sample.
Thanking you in anticipation.
Regards Steve

Welcome to the Forum! sorry,,,but I have no spare roller to measure. you will need the length too.

I bet Rodney would be faster than 2 weeks...

http://rodneydickman.com/ca...101b1a3b3304ede5d802

[This message has been edited by Gall757 (edited 06-07-2015).]